UMI Shock Mounts

Key Features: Laser cut for consistency and a precise fit. Powder coated black for a long lasting finish. Upper T-bar reinforcement tab and hardware included. " x 1-" mount fits most standard racing shocks. 100% Bolt in design features shock height adjustability. Optional shock tower reinforcement brace available. (P/N 3055) Designed, tested, manufactured and raced in Philipsburg, PA-USA Brackets manufactured entirely from 3/16" Made In USA mild steel. Rear shocks may not clear all exhaust tail pipes. UMI is not responsible for exhaust clearance issues. Optional Shock Tower Brace P/N 3055- P/N 3055 is designed to tie the left and right rear shock towers together for additional chassis reinforcement. UMI's P/N 3055 has been designed to clear most popular exhaust systems however fitment with all exhaust systems is not guaranteed. Installation & Fitment Note: Coilover brackets are designed to fit factory rear end housings ONLY and may not fit aftermarket rear ends. Coilover kit P/N 3049 offers more clearance and options for aftermarket rear ends than P/N 3048. UMI recommends installing the 3049 bracket kit, setting the ride height as desired, then purchasing the correct length shocks. Contact us for recommendations. UMI's bolt-in rear coilover bracket kit is a complete mounting solution for your factory axle 1978-1988 GM G-Body. This race-proven lower bracket bolts in using the standard trailing arm mounting hole as well as an additional reinforcement hole normally used by the standard rear shock. This bracket features a multi-position design to allow further fine tuning of ride height and shock location ("). The kit also features upper reinforcement tabs to distribute the load from the T-bar as well as complete upper and lower hardware. There is no cutting required and your car can be returned to stock at any time. 100% designed, manufactured and raced out of Philipsburg, PA-USA and always US materials. 3049 - 1978-1988 GM G-Body Rear Coilover Bracket Kit, Bolt-In, Brackets Only.